We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

How to Stop Leaky Bathroom Faucet: 5 Steps to Fix a Drip for Good

Learn how to stop leaky bathroom faucet drips with five practical steps: find the source, shut off water, replace worn parts, and test your fix.

Updated November 2026

To stop a leaky bathroom faucet, you need to find where the water is escaping, shut off the supply, and replace the worn part causing the drip. Most leaks come from a worn washer, cartridge, O-ring, or valve seat, and the repair usually takes under an hour with basic hand tools. This guide walks you through each step so the drip stops for good.

Identify Where the Leak Is Coming From

Before you take anything apart, figure out exactly where the water is escaping. A faucet can leak from three places, and each points to a different fix.

Shopping for one? See our guide: Bathroom Leaky Faucet Repair Kits: 7 Best Picks Compared (2026).

  • Spout drip: Water falls from the spout even when the handle is fully closed. This usually means a worn washer, cartridge, or valve seat inside the faucet body.
  • Base leak: Water pools around the base of the faucet or drips under the sink. Check the O-rings and the supply line connections.
  • Handle leak: Water seeps out around the handle when the faucet is running. The packing nut or handle O-ring is the likely cause.

Run the faucet for a few seconds and watch closely. If the water flows from the spout, you are dealing with an internal drip. If it wets the base or handle, the problem is a seal.

Shut Off the Water and Prepare Your Tools

Turn off the water supply before you remove any parts. Most bathroom sinks have two small shutoff valves under the vanity, one for hot and one for cold. Turn them clockwise until they stop. If the valves are stiff or do not close fully, shut off the main water supply to the house.

Open the faucet to drain the remaining water in the lines. Then place a towel in the sink basin so small parts cannot fall down the drain.

You will typically need:

  1. An adjustable wrench and a set of Allen (hex) keys
  2. A flat-head screwdriver and a Phillips screwdriver
  3. Replacement washers, O-rings, or a cartridge that matches your faucet brand
  4. Plumber’s grease and a rag

Replace the Worn Part Causing the Drip

Once the water is off, remove the handle and access the internal components. Remove the decorative cap, loosen the handle screw, and lift the handle off. Then unscrew the packing nut or cartridge retaining clip, depending on your faucet style.

Compression faucets (two handles)

Remove the stem, then inspect the rubber washer on the bottom. If it is flattened, cracked, or deformed, replace it and check the brass valve seat for pitting. A worn seat can be resurfaced with a seat-dressing tool or replaced.

Cartridge faucets (single handle or modern two-handle)

Remove the cartridge, which is a single unit that controls water flow. Take the old cartridge to a hardware store to confirm the replacement matches. Install the new cartridge with its alignment tabs facing the correct direction, then reattach the retaining clip.

Ball and disc faucets

Replace the rubber seats and springs, and check the O-rings around the ball. Clean any mineral deposits from the internal parts before reassembly.

Apply a thin layer of plumber’s grease to new O-rings before installing them. This helps them seat properly and reduces wear.

Reassemble, Restore the Water, and Test

Reassemble the faucet in the reverse order you removed it. Tighten the packing nut snugly, but do not overtighten, since this can crack washers or strip threads. Reattach the handle and decorative cap.

Turn the shutoff valves back on slowly. Open the faucet and let air escape, then close it. Check the spout and base for at least five minutes. If the drip persists, the valve seat may be damaged, and you may need a full replacement. For more detailed fixes on specific faucet types, see How to Fix a Dripping Bathroom Sink Faucet: A Step-by-Step Guide or How to Repair a Bathroom Faucet Leak: A Step-by-Step Guide for Beginners.

Common Mistakes to Avoid

  • Skipping the shutoff step, which can flood the vanity or cause a spray of water when parts come loose.
  • Installing the wrong cartridge or washer. Bring the old part to the store or match the faucet brand and model.
  • Overtightening the packing nut, which can crack the washer and cause a new leak.
  • Ignoring the valve seat. Replacing only the washer will not stop a drip if the seat is pitted.
  • Forgetting to clear mineral buildup, which can keep a new part from sealing tightly.

A basic set of supplies makes the repair much easier, especially when you need to match parts.

  • Plumber’s grease: Keeps O-rings flexible and helps them seal against the faucet body. View on Amazon
  • Faucet repair kit: Includes common washers, O-rings, and seals for multiple faucet types. View on Amazon
  • Adjustable wrench: Loosens packing nuts and supply connections without damaging the finish. View on Amazon

FAQ

Why does my bathroom faucet keep dripping after I replace the washer?

The valve seat is often the cause. If it is pitted or corroded, a new washer cannot seal properly, so the seat may need resurfacing or replacement.

Can I stop a bathroom faucet leak without taking the faucet apart?

Sometimes, if the leak is from a loose connection. Tightening the packing nut or handle screw may stop a minor leak, but internal drips usually require disassembly.

How do I know whether to repair or replace my bathroom faucet?

If the faucet is old, the finish is failing, or repeated repairs have not worked, replacement is usually more practical. Consult a licensed plumber if you are unsure about the condition of the supply lines.

Conclusion

Stopping a leaky bathroom faucet comes down to finding the source, shutting off the water, and replacing the worn part. Once you know the faucet type, the repair follows a clear sequence. Take your time, keep the parts organized, and test the faucet before you close the cabinet.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our kitchen & bathroom fixtures guides, checking product details against manufacturer specifications and owner feedback.

About the author

Lauren Holland
Lauren Holland

Lauren Holland writes reviews and buying guides for Kitchen Bath Channel.