Leak in Kitchen Faucet: How to Find the Source and Stop It
Learn how to find a leak in kitchen faucet fast, tell base leaks from spout leaks, and stop the drip with simple steps and the right repair parts.
Updated November 2026
A leak in kitchen faucet fixtures usually comes from one of three places: the base, the spout, or the handle. This guide shows you how to pinpoint which one is failing, shut off the water safely, and make the most common repair, which is replacing a worn cartridge, seal, or O-ring. Most fixes take under an hour with basic hand tools.
Find Where the Water Is Coming From
Dry the faucet completely with a towel, then run the water for about 30 seconds and watch closely. If water pools at the base of the faucet or drips from under the sink, the leak is likely in a supply line, a mounting nut, or the seal between the faucet and the countertop. If water drips from the spout after you shut the handle off, the cartridge or valve seat is worn. If water seeps out around the handle or the sprayer hose, the O-ring or handle packing is the likely culprit.
Shopping for one? See our guide: Top 7 Kitchen Water Faucet Repair Kits Compared for Common Leaks.
Shut Off the Water and Prepare the Work Area
Close the shutoff valves under the sink by turning them clockwise until they stop. If the valves are stiff or do not seal, close the main water supply to the house instead. Open the faucet to relieve remaining pressure, then place a towel in the sink basin so small parts cannot fall down the drain.
Tools and Supplies You Will Need
- Adjustable wrench and a flashlight
- Allen (hex) key set, often sized 3 mm to 5 mm
- Plumber’s grease and a small screwdriver
- Replacement cartridge, O-ring kit, or washer set matched to your faucet brand
- Bucket and rags for residual water
Replace the Failed Part
Remove the handle by loosening the set screw, usually hidden under a decorative cap or at the base of the handle. Pull the cartridge or stem straight out, noting its orientation. Compare the old part with the replacement before reinstalling anything. Apply a thin layer of plumber’s grease to new O-rings and the cartridge seal, then reassemble in reverse order. Keep the hot and cold sides aligned the same way they were before disassembly.
If the leak is at the spout base, check the mounting nut under the sink. Tightening it can stop a leak, but overtightening can crack a plastic body or distort the seal, so snug it only until movement stops. Repairs to a supply line or shutoff valve may call for a licensed plumber if the valves are corroded or leak when closed.
Test the Repair and Check for Hidden Leaks
Turn the shutoff valves back on slowly to avoid a pressure surge. Run the faucet on hot, then cold, and check every joint. Leave a dry paper towel under the base for an hour and inspect it. Even a small leak can show up as a damp spot, which means the repair is not finished.
Recommended gear
- Silicone plumber’s grease: lubricates O-rings and cartridge seals so they seat without tearing. View on Amazon
- Faucet cartridge puller: helps remove a stuck cartridge without damaging the valve body. View on Amazon
- Hex key set: covers the set screw sizes used on most kitchen faucet handles. View on Amazon
Common Mistakes to Avoid
- Skipping the shutoff step and spraying water across the cabinet floor.
- Buying a part by faucet color or finish instead of by brand and model number.
- Using petroleum jelly on rubber seals, which can cause them to swell and degrade.
- Forcing a stuck handle instead of checking for a hidden set screw or cap.
- Assuming a dripping spout is always a cartridge problem when the valve seat may be worn.
FAQ
Why does my kitchen faucet keep leaking after I replaced the cartridge?
The new cartridge may be installed in the wrong orientation, or debris may be trapped in the valve seat. Remove the cartridge, flush the water lines briefly, and reinstall it carefully with the alignment tab correctly seated.
Can I fix a faucet leak without turning off the main water?
Often yes, if the under-sink shutoff valves seal fully. If they drip or do not close, shut off the main supply to avoid flooding.
When should I call a plumber for a kitchen faucet leak?
Call a licensed plumber if the leak comes from a corroded supply line, a cracked faucet body, or a shutoff valve that will not close. Persistent leaks behind walls or under the cabinet can also indicate hidden water damage that a professional should assess.
Conclusion
A leak in kitchen faucet hardware is almost always traceable to a worn cartridge, seal, or fitting. Identify the leak location, shut off the water, and replace the matching part with care. A short test afterward confirms the repair holds.
Related reading
- Pfister Kitchen Faucet Repair: 5 Steps to Stop Leaks and Drips
- Moen Faucet Drips Kitchen: How to Find and Stop the Leak (Step-by-Step)
- 3 Best Delta Kitchen Faucet Leak Repair Kits for Common Fixes (2026)
Ready to choose one?
